Security Camera Night Vision Range Calculator

A camera's night range on the box is only half the story. Enter its infrared range and lens specs, and see how far it can really pick out a person after dark.

Your camera

Units
ft

The infrared or night vision distance on the spec sheet.

ft

Optional. Some makers list a viewing range too. Leave it blank if yours doesn't.

px

The first number in the resolution, such as 2560 in 2560 x 1440.

°

From the spec sheet. Use the horizontal figure, not the diagonal one.

ft

From the ground to the lens.

What it sees at night

-

out along the ground before the night view stops, for a face 5' 3" up

Night view stops at-
Set by-
Detect reach in daylight, for comparison-
Night detail zones along the ground. The dashed part is past the night view, where the picture goes dark.
How far each detail zone reaches at night
Zone at nightNeedsReaches out to

This is an estimate. It only uses the numbers you entered and the assumptions listed below.

What this estimate assumes

  • The night view stops at the shorter of the camera's range and its night vision range, measured in a straight line from the lens.
  • Glass, such as windows and sliding doors, blocks the view at night because infrared light bounces off it. Open doorways don't.
  • Detail zones use the IEC 62676-4 (2014) levels: detect at 25, recognize at 125 and identify at 250 pixels per meter. They are counted at a face 1.6 m (5' 3") up, at the straight-line distance from the lens.
  • Lenses under 180° are worked out as ordinary lenses. Wider lenses are taken to spread their pixels evenly.
  • The maker's night vision range holds on a clear night with no other light. Rain, fog, dark clothing and dirt on the lens shorten it.

Two limits decide what you see after dark

At night, a camera lights the scene with its own infrared LEDs. Past the rated night vision range, there isn't enough light to see. Inside that range, the usual pixel limits still apply, so a person can be lit but too small to identify.

That's why the tool takes the shorter of the two for each zone. A 2560 pixel camera with a 100° lens reaches the detect level about 140 feet out in daylight. If its infrared range is 30 feet, the night view ends at 30 feet.

Why light fades so fast

Infrared light spreads out as it travels, following the inverse-square law. Twice as far means a quarter of the light. So the picture is bright near the camera and grows dim and grainy toward the edge of the range.

Glass is the biggest surprise. Reolink explains that the camera's own infrared bounces off a window and washes out the picture. An indoor camera aimed through a window sees almost nothing at night.

More camera tools

Check daytime detail with the security camera pixel density calculator, and the width of the picture with the security camera field of view calculator. For alarms and lights, the motion sensor coverage area calculator works out floor area. Every tool is listed on our smart home planning tools page.